HOW TO INSTALL THE PTO LINK®
Installation & Measuring Instructions
IMPORTANT Pre-Installation Measurements
- BEFORE INSTALLATION, WATCH the DRIVELINE MEASURING VIDEO GUIDE (above) and READ ALL OPERATIONAL SPECS (found in the PTO Link Operator/User Manual).
- Why? Since the PTO Link® system adds approximately 114 to 127 mm in length to the driveline, you must measure and, if necessary, shorten (cut) the implement shaft to ensure proper driveline length for safe operation. Prior to installing the PTO Link® system, see the numbered instructions below & video guide (1st video guide below) on whether to shorten an implement driveline. Also see possible variables (found at FAQ #5, #6 & #7) and below for exceptions and accurately measuring the actual length in your situation. Please call Customer Care on 01433 711 922 if you have further questions after watching the video guide for determining whether your implement shaft needs adjustment. This video guide will also provide guidance on how much of an adjustment is needed – if any.
- DURING & AFTER INSTALLATION: When first installing the PTO Link® Female coupler to the tractor’s PTO: (see PTO Link Operator/User Manual for more details/photos)
- Clean any dirt, debris or rust off the tractor’s PTO shaft and from inside the female receiver of the implement shaft, using a wire brush, penetrating oil and/or lubricant to ease connectivity.
- The PTO housing area should be clear of any obstruction, with a minimum vertical rotational distance to accommodate the full diameter of the PTO Link® system both before and after hydraulic lift. (A diameter of 102 mm for the Compact model and a diameter of 127 mm for the HD model).
- Most tractors with PTO shafts 76 mm or less in length should use the PTO Link® Compact system. For possible exceptions, please call our Customer Care line. (A list of known tractors requiring the Compact System can be found on our shop page).
- Did you hear the click of the ball bearings fastening into the notch on the PTO shaft?
- Did you give the installed female coupler a firm tug to ensure it is locked in place? Once properly installed, the top of the female coupler collar (C-Clip area) should not rest against or make any contact with any part of the PTO housing. Any such contact may damage your tractor’s PTO oil seal, PTO housing and/or damage the PTO Link® system’s connectivity to your tractor’s PTO.
- Once the couplers are installed and connected, always insert the enclosed Safety Plunger Pin (from the tractor side) or the Safety Bolt (from tractor or implement side), through both couplers of the PTO Link® system, with the spring release wedge/ball detent emerging from the opposite side.
- Once the couplers are installed and connected, always insert the enclosed Safety Plunger Pin (from the tractor side) or the Safety Bolt (from tractor or implement side), through both couplers of the PTO Link® system, with the spring release wedge/ball detent emerging from the opposite side.
